SATURN
EPABX
Installation Test Procedures
Issue 1, May 1986
Table 6.05 Console Test (Continued)
IS NOT OBTAINED
6
Depress the console’s keypad buttons
All digits dialed are displayed
I f p r o p e r v e r i f i c a t i o n i s n o t o b t a i n e d o r
in the following sequence: 1, 2, 3, 4,
c u m u l a t e ) .
busy tone is returned at any time, the
5, 6, 7, 8, 9, 0, and
keypad buttons or console buttons
were depressed out of sequence, the
7
Depress the console’s feature buttons
E a c h b u t t o n L E D l i g h t s w h e n
console is defective, or
circuit
i n t h e s e q u e n c e s h o w n i n F i g u r e 6 . 1 9 . ’
depressed and extinguishes when the
i s d e f e c t i v e . T o i s o l a t e t h e f a i l u r e , r e t r y
next key is depressed.
test to verify that the buttons were not
depressed out of sequence.
a
After the last button in the sequence
G r o u p s o f e i g h t o f e a c h o f t h e
I f p r o p e r v e r i f i c a i i o n i s n o t o b t a i n e d o r
is depressed, depress any console
able characters are scrolled in the se-
busy tone is returned again, replace
b u t t o n t o i n i t i a t e t h e d i s p l a y t e s t . T h e
s h o w n i n T a b l e 6 . 0 6 .
t h e
a s s o c i a t e d
P C B t o v e r i f y
d i s p l a y c a n b e s u s p e n d e d b y
last character is displayed (under
whether the
circuit or the
depressing any key on the console
score character), the display unit is
sole is defective. If proper verificaiion
and resumed in the same manner.
cleared and the following
is obtained, replace the
momentarily light then extinguish in
P C B . I f p r o p e r v e r i f i c a t i o n i s n o t
the following sequence:
obiained or busy tone is returned
again, replace the console.
a) TRUNK GROUP STATUS 1
b)
c) DESTINATION
d) ALERT
e) CW
ALM
g) MIN ALM
After the above indications are com-
pleted the
indications occur:
tone is returned.
All
on the display assembly
f l a s h . .
.
After the above indications are com-
p l e t e d t h e f o l l o w i n g i n d i c a t i o n s o c c u r :
tone is returned.
All
on the display assembly
flash.
T h e a u d i b l e a l e r t i n g d e v i c e s o u n d s a t
i n t e r v a l s .
REMOVE HANDSET is displayed.
9
Remove and reinsert handset
INSERT HANDSET is displayed while
bly to terminate test, or wait 30
handset is removed. After handset is
for test timeout.
reinserted, console returns to normal
o p e r a t i o n .
1 0
If no additional apparatus tests are to
be performed, proceed as follows:
Place maintenance test phone Dial tone is returned.
off-hook.
D i a l t h e D i a g n o s t i c T e s t A c c e s s C o d e .
Recall dial tone is returned.
Dial 2 to disable the Apparatus Tests.
N o n e .
P l a c e m a i n t e n a n c e t e s t p h o n e N o n e .
on-hook.
6 - 1 7
