Siemens RUGGEDCOM RS900W, Руководство по установке

Страница: 25 / 44

RUGGEDCOM RS900W
Installation Guide
Chapter 2
Installing the Device
Connecting to the Device 15
IMPORTANT!
The serial console port is intended to be used only as a temporary connection during initial
configuration or troubleshooting, and should only be used in a safe area (as defined by IEC 60079-0,
Edition 6.0).
Use the following settings to connect to either port:
Speed 57600 Mbps
Data Bits 8
Stop Bit 1
Parity None
Flow Control Off
Terminal ID VT100
Speed 57600 Mbps
The serial console port implements RS232 DCE (Data Communication Equipment) on a DB9 connector. The
following is the pin-out for the port:
1 5
9
6
Figure 9: Serial DB9 Console Port
Pin Name Description
1
a
Reserved (Do Not Connect)
2 TX Transmit Data
3 RX Receive Data
4
a
Reserved (Do Not Connect)
5 GND Signal Ground
6
a
Reserved (Do Not Connect)
7
b
Reserved (Do Not Connect)
8
b
Reserved (Do Not Connect)
9 Reserved (Do Not Connect)
a
Connected internally.
b
Connected internally.
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch and access the RUGGEDCOM
ROS console and Web interfaces via the device's IP address. The factory default IP address for the RUGGEDCOM
RS900W is https://192.168.0.1 .
For more information about available ports, refer to Chapter 3, Communication Ports .