Siemens RUGGEDCOM RS416PF, Руководство по установке

Страница: 39 / 56

Communication Ports
4.4 Serial Ports
Serial DB9 Port with IRIG-B Support
6 9
5 1
Figure 4.10 Serial DB9 Port Pin
Configuration
Mode Pin
RS232 DTE RS485 RS422
1 RX-
2 RX
a
TX/RX+ TX+
3 TX
a
RX+
4 IRIG-B+
5 Common (Isolated) Ground
6 Common (Isolated) Ground
7 RTS TX/RX- TX-
8 CTS
9 Common (Isolated) Ground
Shield Chassis Ground
a
In RS232 DTE mode, ports transmit to DTE devices on pin 2 and receive from DTE on pin 3.
Note
Pins 7 and 8 are connected internally. In RS232 mode, these pins enter a high
impedance state. A DTE that asserts RTS will see CTS asserted. However, the device
will not perform hardware flow control.
Serial RJ45 Port
8 1
Figure 4.11 Serial RJ45 Port Pin
Configuration
Pin RS232
Mode
RS485
Mode
RS422
Mode
1 DSR
a
RX-
2 DCD
a
3 DTR
a
4 Common (Isolated) Ground
5 RXD
b
RX+
6 TXD
b
TX/RX+ TX+
7 CTS
8 RTS TX/RX- TX-
Shield Chassis Ground
a
The DSR, DCD and DTR pins are connected together internally.
b
In RS232 mode, the RJ45 ports conform to EIA-561 DTE, which transmit on TXD and receive on RXD.
Note
Pins 1, 2 and 3 and pins 7 and 8 are connected internally. In RS232 mode, these pins
enter a high impedance state. A DTE that asserts RTS will see CTS asserted. However,
the device will not perform hardware flow control.
30
RUGGEDCOM RS416PF
Installation Manual, 04/2021, C79000-G8976-1355-04