Siemens PolyCool CPS 40, Инструкция по установке и эксплуатации, Страница: 49 / 124

Picture Display Procedure
13 MOP
Press <OK> to confirm and
proceed
MOP SP (Setpoint of MOP)
(15 °C / 59 °F default)
MOP XP (P-band of MOP)
(5 K / 9 °F default)
MOP TN (integral action time of MOP)
(30 s default)
In picture 13, set with +/-
Continue/confirm with <OK>
Exit with <ESC>
Continously press <ESC> and back to picture 13
14 SAFETY (safety control)
Press <OK> to confirm and
proceed
VD (Valve startup delay time)
(0
default)
VO (Valve startup opening limit)
(0
default)
PA (alarm delay of pressure sensor time when
compressor ON)
(5 s default)
TL (Low limit for temperature measurement)
(-40 °C / -40 °F default)
MI (Minimum superheat ∆ T)
(2 K / 3.6 °F default)
In picture 15, set with +/-
Continue/confirm with <OK>
Exit with <ESC>
Continously press <ESC> and back to picture 14
15 SIMU MODE (simulation mode)
Press <OK> to confirm and
proceed
16 MAN EIV (manual opening of the valve by means of
internal DC 0...10 V signal)
Caution! At your own risk!
May cause serious damage to the compressor!
In picture 15, press <OK>
Exit with <ESC>
17 EIV (the actual position of EIV to the manipulated
opening MAN EIV) In picture 16, press <OK>
again.
18 TO (actual value of evaporation temperature)
TOH (actual value of suction gas temperature)
In picture 17, set with +/-
Continously press <ESC> and back to picture 15
49/124
Building Technologies CPS40 CE1U3372XX / H 74 319 0555 0 a
HVAC Products 22.09.2006