Siemens ER12553EU, Инструкция по эксплуатации, установке и уходу

Страница: 9 / 28

9
Installation
(for the installer)
Picture 1
Picture 2
Installation must be made by a kitchen installation
expert.
Note: If you intend to have the gas hob welded into
a stainless steel worktop, for safety reasons and in
order to fully maintain the requirements of your
Siemens warranty, we recommend that this type of
installation be done
solely through our designated
partner: Bautek. (Address available on request).
IMPORTANT!!!
The countertop must have a thickness of 30 mm and
a maximum of 40 mm. Do not use liquid silicone to
glue the hob to the countertop.
The furniture below the countertop should have an
opening for passage of the gas pipe and electric
wires measuring at least 50x50 mm. Any eventual
cabinet, resting on the worktop, at any of the two
sides of the hob, and the upstand on the back of the
hob, each must be at least 50 mm from the edge of
the hob itself. In case of elements sold complete
with cabinet, the instructions for installation of the
cooker hob are provided in the manual for the
cabinet.
Apply the sealing gasket along the edge of the
opening taking care to overlap the joints (picture 1).
Fit hook B in angle iron A welded on the unit
(picture
2) taking care to block it in the holes
provided, depending on the thickness of the
countertop (30 mm, max. 40 mm), picture 3.
Turn tab C and position it under the countertop, then
tighten screw D. Trim, if necessary, the part of the
gasket extending beyond the cooker hob.