SIEMENS ADSL E-110_E-110-I user manual
Sub-Menus
For advanced mode, the following sub-menus are available:
Lan
LAN Config
Sets LAN configuration, which determines you the device is defined in the network.
DHCP Mode
Sets and configures the Dynamic Host Configuration Protocol mode for the device.
With DHCP, IP addresses for your LAN are administrated and distributed as needed
by this device or an ISP device.
DHCP Server
Lists the IP address pools available to computer on your LAN. The device distributes
numbers in the pool to devices on your network as they request Internet access
(refer to “Configuring DHCP Server”).
DHCP Relay
Lists each interface on the device that relays data from your ISP. As a DHCP relay
agent, when a computer request Internet access, the device requests an IP address
from your ISP, and then relays the addresses back to the computer (refer to
“Configuring DHCP Relay”).
Wan
DSL
Displays configuration parameters and performance statistics for the ADSL Router’s
DSL line (refer to “View DSL Parameters”).
ATM VC
Configures and displays an ATM virtual circuit (VC). The VC properties define the
path that the ADSL Router uses to communicate with your ISP over the ATM
network.
PPP
Configures and displays Point to Point Protocol (PPP) interfaces. The PPP protocol is
commonly used between ISPs and their customers to identify and control various
communication properties (refer to “PPP Connection Mode”).
EOA
Configures and displays RFC1483/Ethernet over ATM (EoA) interfaces. The EoA
protocol is commonly used to carry data between LANs that use the Ethernet
protocol and WANs that use the ATM protocol.
IPOA
Configures and displays IP over ATM (IPoA) interfaces. An IPoA interface can be
used to exchange IP packets over ATM network, without using an underlying EoA
connection (refer to “Router Connection Mode”).
Bridge
Bridging
Configures and displays Bridging information (refer also to “Bridge Mode”).
LAN Config
Sets LAN configuration, which determines you the device is defined in the network.
DSL
Displays configuration parameters and performance statistics for the ADSL Router’s
DSL line (refer to “View DSL Parameters”).
ATM VC
Configures and displays an ATM virtual circuit (VC). The VC properties define the
path that the ADSL Router uses to communicate with your ISP over the ATM network.
RFC
1483
Interface (EoA)
Configures and displays RFC1483/Ethernet over ATM (EoA) interfaces. The EoA
protocol is commonly used to carry data between LANs that use the Ethernet
protocol and WANs that use the ATM protocol.
Routing
IP Route
Lists IP addresses of Internet destinations commonly accessed by your network.
When a computer requests to send data to a listed destination, the device uses the
Next Hop to identify the first Internet router it should contact to route the data most
efficiently (refer to “Configuring IP Routes”).
IP Addr
Displays all IP addresses associated with ports on your device, including the LAN
(Ethernet) port and the WAN (DSL).
LAN Config
Sets LAN configuration, which determines you the device is defined in the network.
DSL
Displays configuration parameters and performance statistics for the ADSL Router’s
DSL line (refer to “View DSL Parameters”).
ATM VC
Configures and displays an ATM virtual circuit (VC). The VC properties define the
path that the ADSL Router uses to communicate with your ISP over the ATM network.
38
Rev:01_040220