5
Creating Project Files—Modbus Master to Devices
32
Siemens Energy & Automation, Inc.
5.4
Device Setup—Port 2
One or more Siemens devices may be connected to
port 2. You must have a Modbus Master to Devices
project file open to configure port 2 using the instruc-
tions in this section.
Select
Port 2 (Devices)
from the
Edit
menu, and the
Port 2 configuration screen appears.
Device Protocol
The
Device Protocol
indicates which Siemens devices
can be connected to port 2. This protocol is based on
which version of the DTU3005 Editor software was
installed as described in
Chapter 2
.
•
The
SEAbus
protocol (as shown in the example
screen above) indicates connection to Siemens
ACCESS communicating trip units, relays, power
meters and other devices.
•
The
VDEW
protocol indicates connection to Sie-
mens protective relays using the VDEW protocol.
Note: Not all Siemens devices are supported. For
a list of supported devices, see
Appendix B
.
Other Configuration Information
The remaining configuration selections are the same
as those for port 1. Refer to
Section 5.3
for instructions
on these fields.
Saving Port 2 Configuration Information
Once you have entered all the configuration informa-
tion, select
Save
to save the configuration to the
project file. Then select
Ok
or press the
Esc
key to
close the configuration screen.
If you have changed the configuration and have not
saved it to the project file, you will be prompted to
either save or discard the changes.
Select
Revert
to return to the last previously saved
configuration without saving any changes.
