en
Installation instructions
56
3.
Guide the supply hose downwards within the recess
.
4.
Open the hose clamps and reinsert the supply
hose.
5.
Install the supply hose with connection elbow on the
domestic connection.
Only tighten the plastic union nut by hand.
Do not subject the supply hose to tension, trap or
squash it, or bend it too tightly.
If the hose length is not sufficient, you can use a
hose extension. A Z7710X0 hose extension with a
length of 2 m is available from customer service.
6.
Check the water connection for leak-tightness.
In the event of a leak, stop the water again immedi-
ately and tighten the connection.
32.10 Installing the appliance
1.
Slide the appliance in fully and centre it.
2.
Screw the appliance into place.
3.
For handleless kitchens with vertical bar handle
strips:
‒
Attach a suitable filling piece in order to cover
any sharp edges and to guarantee a safe install-
ation.
‒
Pre-drill aluminium profiles to establish a screw
connection .
‒
Secure the appliance using a suitable screw .
Note:
The gap between the worktop and the appliance
must not be closed by additional battens.
Thermal insulation strips must not be fitted to the side
panels of the surround unit.
32.11 Removing the appliance
1.
Empty the steam system.
Use the rinsing function to do this.
2.
Disconnect the appliance from the power supply.
3.
Undo the fastening screws.
4.
Lift the appliance slightly and pull it out completely.
