Siemens APACS+, Инструкция по установке и обслуживанию

Страница: 58 / 65

Circuit Description SD39EAM-1r4
4-6
September 2005
Board Problems
•
Backplane Power Failure
•
Internal Module Overtemperature
•
RAM Checksum
•
ROM Checksum
•
Redundancy Switch-Over
An OK LED and an ACTIVE LED on the module’s bezel provide a local indication of the following
module status:
•
Module OK
•
Channel(s) Faulted
•
Module Faulted
•
Module Not Configured
•
IOBUS Communication Fault
•
Module Active (Redundancy Primary)
•
Module Inactive (Redundancy Backup)
The OK LED is the principal error annunciator. At initial turn on, the EAM’s CPU uses a common start
up routine to perform certain self-diagnostics, such as ROM and RAM tests, and to setup specific board
functions. If the common start up routine is successful, the OK LED will be set to a solid green color and
the EAM begins to execute common I/O board diagnostics; if not successful, the OK LED will be set to a
flashing red color at a 1 second flash rate.
The ACTIVE LED lights to a solid Green if the module is enabled. A redundant EAM in the standby
mode will show a solid Green OK and Black (OFF) ACTIVE LEDs.
All errors generated by the diagnostics are reported to the control module (ACM), which maintains a
current error log that can be accessed by any APACS+ operator interface or the
4-mation configuration
software. The 4-mation software also provides additional diagnostic and status displays.
„