OPERATION
_________________________________________________________________________________________________________
7-4
COM-00-21-03 OCTOBER 2021
Version No.: A
Tx iTrim :
:
-35
Up-link DC offset real
Tx qTrim :
:
-87
Up-link DC offset imag
Doppler Feq Est :
:
0
Doppler frequency offset
Second LNA enable :
:
1
Second LNA Parameter
Current UL FEC Code:
:
5
Uplink modulation
Current DL FEC Code:
:
5
Downlink modulation
Power Control Mode:
:
Hybrid power control
mode
Uplink Power control mode
For a full description of the CLI commands, refer to the Mercury Command Line Interface (CLI)
Manual.
7.2.3 Temporary Operational Non-Permanent Changes (No Reboot Required)
This section describes the recommended techniques for managing temporary non-permanent
configuration changes in an experimental test environment.
CLI commands can be used to change certain parameters for test purposes. These changes
are not permanent and are undone whenever the system is rebooted. Any changes to the
configuration files that are intended to be permanent need to be made by editing the
configuration files directly in WinSCP or through Apollo.
The following parameters can be changed temporarily:
1. Change the maximum and minimum transmit power for Mercury.
Set Minimum Remote Station transmit power type as shown in Figure 7-5. The
Minimum transmit power range is 0 to 25 dBm
Figure 7-5 Set Minimum Remote Station Power
Set Minimum Remote Station transmit power type as shown in Figure 7-6. The
Maximum transmit power range is 0 to 25 dBm.