ULTRAMAT 6 / OXYMAT 6 / CALOMAT 6 / ULTRAMAT 23 / OXYMAT 61
Schnittstelle PROFIBUS DP / PA Interface
A5E00054148-03
95
Status coding for ULTRAMAT/OXYMAT/CALOMAT:
Status coding for "bad quality"
Dec Hex
Cause
Remedy
11
0B
Component missing
Change configuration, install analyser including this
component
12
0C
Device error
Check with SIMATIC PDM / change analyzer
31
1F
Out of order (equivalent value,
last valid value, through connect
value)
Depending on the paramterization. Switch in mode AUTO
Status coding for "uncertain quality"
Dec Hex
Cause
Remedy
64
40
Function control
Warm up, AUTOCAL, in situ service
71
47
Measured value is bad,
last valid value
Check with SIMATIC PDM / change analyzer
75
4B
Measured value is bad,
equivalent value
Check with SIMATIC PDM / change analyzer
79
4F
After switching on the power,
initial value
Reject the measured value
80
50
Measured value is out of range
Check with SIMATIC PDM / ambient temperature too high
Status coding for "good quality"
Dec Hex
Cause
Remedy
128
80
o.k., normal operation
You can evaluate the measured values
132
84
Active block alarm, parameter
has been changed
Disappears after 10 seconds
137
89
Lower warning limit exceeded
user programm
138
8A
Upper warning limit exceeded
user programm
141
8D
Lower alarm limit exceeded
user programm
142
8E
Upper alarm limit exceeded
user programm
164
A4
Maintenance request
Check with SIMATIC PDM