Siemens 6SL3210-1PE21-1AL0, Руководство пользователя

Страница: 59 / 70

Siemens PM240-2_EN_rev00-30082019.docx 11-3
p21530 Short Floor activate 0
1 0
p21548 Short Floor Speed Up (2.14.2) 0.160 % 0.800 0.200
p21549 Short Floor Speed Down (2.14.3) -0.110 % -0.800 -0.200
p21651 Short Floor Ramp Factor 1.000
NA NA
COMPENSATIONS – COMPENSAZIONI
p21570 Switch tipologia olio 0
NA NA
p21571 P.X1 0.900
4.000 0.000
p21572 P.X2 0.800
4.000 0.000
p21573 P.X3 0.200
4.000 0.000
p21574 P.X4 0.300
4.000 0.000
p21575 P.X5 0.250
4.000 0.000
p21576 P.X6 0.200
4.000 0.000
p21577 P.X7 1.000
4.000 0.000
p21578 P.X8 1.600
4.000 0.000
p21579 P.X9 1.000
4.000 0.000
p21580 P.X10 0.200
4.000 0.000
p21581 P.X11 2.900
4.000 0.000
p21582 P.X12 1.000
4.000 0.000
AUTOTUNING - AUTO REGOLAZIONE
p21600 Torque Measure without load 0
1 0
p21601 Torque Measure with full load 0
1 0
TORQUE VALUES - VALORI COPPIA
p21590 Ascending Torque Min Value 29.731 Nm NA NA
p21591 Ascending Torque Max Value 51.892 Nm NA NA
p21592 Ascending Comp Value 0.030 % NA NA
p21595 Descending Torque Min Value -8.194 Nm NA NA
p21596 Descending Torque Max Value 9.558 Nm NA NA
p21597 Descending Comp Value 0.035 % NA NA
NOTE: (*) all speeds are expressed in rpm% compared to the rated motor speed (usually 3000 r/min)
11.4 CONFIGURATION PARAMETERS
For both directions, it is necessary to adjust some values to your system:

Set the desired value for the high-speed P21507 (2.2.6) (P21537 (2.3.6) for downward).

Set the desired value for the low speed P21512 (2.2.7) (P21542 (2.3.7) for the downward).

Set the desired value for the inspection speed P21514 (2.2.9) (P21544 (2.3.9) for the downward
direction).