SIEMENS 5881 Broadband Internet Router
User’s Guide
Chapter 3 Easy Setup
Select Protocol
SIEMENS
18
Using PPPoE
If you will use the Point-to-Point Protocol (PPP) to establish the connection., you selected
Using PPPoE
.
Perform the following steps to complete setting up the router.
1. Enter the
User Name
and
Password
, which are used for authentication when the PPP connection is being
established.
2. In
Service Name
, enter the domain name of your network service provider. Use * as a default (for all
services).
3. In
PPPoE Timer
, enter the number of seconds of inactivity that must elapse before the PPP connection
closes. This helps to limit connection charges from your service provider during times of inactivity. The
default entry of “permanent” will keep the PPP connection open constantly, with no time out interval.
4. Optionally select
NAT Enabled
to enable Network Address Translation (NAT). NAT allows multiple
workstations on your LAN to share a single, public IP address. All outgoing traffic appears to originate from
the router’s IP address.
5. Click
Next
. This displays the
Dynamic Host Configuration Protocol
page.
Not Using PPPoE
If you will establish the connection based on IP addressing, you selected
Not Using PPPoE
. Perform the
following steps to complete setting up the router.
1. IP Routing routes all IP packets for remote hosts to the WAN. Specify how to obtain an IP address and
subnet mask by selecting one of the following:
•
Obtain configuration automatically
from Wan using DHCP
to have an IP address assigned
automatically using DHCP.
•
Configure IP Routing manually
to assign IP addresses manually. If you select this option, you must
specify an
IP Address
,
Subnet Mask
, and
Default Gateway
in the appropriate fields.
Default Gateway
assigns the IP address of the next-hop device.
2. Optionally select
NAT Enabled
to enable Network Address Translation (NAT). NAT allows multiple
workstations on your LAN to share a single, public IP address. All outgoing traffic appears to originate from
the router’s IP address.
3. Click
Next
. This displays the
Dynamic Host Configuration Protocol
page.