Siemens Nixdorf RM300 C20, Руководство по эксплуатации

Страница: 41 / 205

Installing the system unit
4
U24801-J-Z146-2-7600 RM300 C Models
31
D
o
k
u
s
c
h
abl
on
en V
e
rs
io
n
3
.2
v
om
2
5
.10.
9
3
©
S
ie
m
en
s
N
ix
d
o
rf
I
n
fo
rm
a
ti
o
ns
s
y
s
te
m
e A
G
199
3
Dr
u
c
k
v
o
m
12
.
0
4
.1
9
99 15
:5
0.
36
P
fad:
H:
\C
h
ri
s
to
p
h
\M
anu
al
e\
P
D
F
\R
M
\R
M
3
00C
B
e
tr
iebs
an
le
it
ung
\eng
lis
c
h
\r
m
3
00.
k
0
4 4.4
Starting up the system unit
The system unit and the monitor must be connected to the same distri-
bution board, as otherwise compensating currents may flow.
The line voltage set on your system must be the same as the voltage
supplied by the building’s wiring system.
Ê Connect the monitor either to the system unit’s power outlet socket or directly
to the power (depending on the type of power cord supplied).
Ê Connect the system unit to the power.
Before you switch on for the first time, the system unit (and the monitor!)
must have stood unpacked at room temperature for at least two hours.
Ê Switch on the monitor before you switch on the system unit.
To switch on the system unit
You can switch on the system unit manually or remotely. After switched on the
system unit the POWER LED will light up green.
After a short delay the connected peripherals cabinets are also switched on
automatically; the ON/BATT LED on these devices also lights up green.
Once the system unit has been switched on, the system performs a self-test routine.
The duration of this routine depends on how your system is configured.
– to switch the system unit on manually:
Ê Insert the black key in the keylock switch on the control panel and turn it
to LOCAL.
Ê Press
[ON/OFF]
– to switch the system unit on remotely:
It is possible to switch on the RM300 remotely via a modem or a connected
terminal.
!
!