38
Last update: 17.12.2014
MHS400
Assembly instructions
2.10 Concealed mains cable fitting and connection - Scheme C
Concealed fitting and connection in the power supply for slide drive SA - Scheme C
Important note:
If the customer is responsible for the fitting of the flexible mains cable (5 x 1.5 mm
2
) for the slide drive SA
and the connection in the power supply of the slide drive SA, this work must be carried out by a
qualified electrician
.
Risk of overheating
Risk of electric shock
›
Prior to assembly, you must disconnect the mains cable from the AC mains power supply or disconnect the mains fuses.
With concealed mains cable fitting and for control using a wall or key switch (not included in scope of delivery), the cable
must be connected in the 5-pin socket of the slide drive SA.
• Unscrew the fixing screws on the 5-pin socket and pull out the plug (Fig. 1).
• Unplug and remove the 2-wire mains plug cable that comes as standard in the power supply (Fig. 2).
• Route the concealed mains cable through the open cable duct (clips open and shut) and cable duct recess into the 5-pin socket
(Fig. 3).
• The isolated part of the mains cable must be located inside the 5-pin socket.
1
2
3
4
Plug
5-pin socket
disassemble
Mains plug cable
unplug and remove
Concealed mains cable
connect
Cable duct
recess
Plug to 5-pin socket
connect and fix
Wiring diagram - Scheme C
•
All-pole
safety isolation is essential.
• Connect the cable inside the 5-pin socket according to the wiring diagram.
• Connect the plug to the 5-pin socket and reattach the power supply cover using the fixing screws (Fig. 4).
PE
N
L1
PE
N
L1
N 1
*F
*F
2 3
N 1
2 3
*All-pole safety isolation
*All-pole safety isolation
Connection
Button
5-pin socket
MHS400
5-pin socket
MHS400
Connection
without switching unit
Connection
without switching unit
Important, consider polarity
N = blue / neutral
1 = brown / phase
2 = black / closed
3 = grey / open
Connection
Key button,
code lock or in-
stallation bus ac-
tuators
