8
AEROMAT VT WRG 1100
Original operating instructions
10.2018
6.3 Installation sequence
1. Remove the AEROMAT VT WRG 1100 carefully from the packaging and do not place it on the weather grille or front
panel. We recommend storing the unit on a soft surface (e.g. cardboard or sheet) during installation.
2. Close the sliders on the front to prevent dirt (e.g. dust) from entering the unit during installation. If the
AEROMAT VT WRG 1100 does not have sliders, tape up the recesses in the front panel with film.
3. Make sure that no dirt and liquids can get inside the AEROMAT VT WRG 1100 including the weather grille prior to the
installation of the exterior insulation or cladding.
Attention!
According to the installation location, it is therefore necessary to adhere the AEROMAT VT WRG 1100 at points
where rain could permeate.
Example
"Concealed installation in the wall
with wall duct"
Example
"Concealed installation in the lintel"
AEROMAT VT
Film
Adhesive tape
Exterior insulation
Adhesive tape
AEROMAT VT
Exterior insulation
Film
Adhesive tape
Adhesive tape
4. Install the AEROMAT VT WRG 1100 in its intended installation position and seal it in accordance with the installation
directives applicable on site.
5. Check AEROMAT VT WRG 1100 for cleanliness prior to starting it up. Clean if necessary (see "care and maintenance"
on page 17).
Attention!
Only drill in through-holes for wall plugs and screws in the area indicated (see marker tape).
Important!
Remove any marker tape that is visible after installation.
6.4 Interruption of installation work
›
Prior to stopping work or while work is interrupted, protect open ends or areas so that no dust or moisture can enter.
