Siebeck GmbH
Translation of the original operating manual
0411 FRT-A-MKIIIbed
d
Page 26
Never use trichloroethylene, perchloroethylene, benzene, nitro
cellulose thinners, petroleum or similar liquids for cleaning. These
agents create dangerous vapours. Risk of explosion and
poisoning !
The machine must be cleaned thoroughly after every use. When
using cleaning agents and disinfectants (max. pH value 8), you must
make sure that these agents are rinsed off completely (leaving no
residue) with clear water.
Do not use cleaning agents which contain chlorine !
Remove the string bobbin before cleaning !
See pages 17 to 23
Adhere to the following when using high-pressure cleaners:
- max. pressure 60 bar
- only use a fan jet, i.e. not a solid jet
- do not point the jet directly at:
the knotting aggregate
drive motors
joints on the control cabinet
operating panel
exposed ball bearings
sealing surfaces.
Procedure :
1. Disconnect the machine from the power supply. Pull the mains plug!
2. First clean the machine from outside
3. Internal cleaning
a) Open the machine hood
b) Clean and rinse the knotting aggregate preferably with a brush
and hot water
c) For further internal cleaning the knotting aggregate should be
covered with a suitable protective foil
d) Remove and clean the dirt pan
e) Clean the remaining internal surfaces of the machine in
accordance with paragraph 3(remove the string bobbin) on this
page
f) Close the hood and clean the external surfaces again
g) Replace the cleaned drip tray