Side-Power SH SERIES, Руководство пользователя

Страница: 14 / 24

14
6032 3 2019
-
SEP user manual
MC_0047
MC_0047
Maintenance
Oil Change
EN
EN
As a part of the seasonal service of your Thruster before every season, always check that:
• The propeller is fastened securely to the gear leg.
• Bolts holding the thruster components together are fastened securely.
• The area around the thruster is clean and dry. Ensure there are no signs of water.
• Paint the propeller and gear leg with antifouling before every season to keep it clean from sea growth. (NB: Never paint the anode, sealings or
propeller shaft. Ensure paint does not enter the space between the propeller and the gear leg. Ensure to use antifouling designed for
drivers)
• Change the zinc anode before every season, or when half the anode has eroded. Always use a sealant or thread glue on the holding screw to
ensure that it does not fall off . (NB: In some water conditions, it may be necessary to install an extra zinc anode to ensure that it lasts for
the whole period between regular service lifts of the boat. Consult your dealer for information on how to do this.)
• Drain oil after fi rst 50 hours of runtime, then with 500 hours runtime intervals. Refi ll with GL-5 gear oil if needed.
• Change the gear oil a minimum of every second year. Check the gear oil quality in the guardhouse every time the boat is out of the water.
• If there is a problem with your Ignition Protected stern thruster, please contact your dealer.
OIL LUBRICATION GEAR LEGS : There must always be oil in the oil reservoir. Refi ll if necessary with gear oil EP90. Change the gear oil a minimum
of every second year. Check the gear oil quality in the gear house every time the boat is out of the water.
2. To drain the gear leg unscrew lower oil drain screw.
3. Unscrew upper oil drain screw.
4. The oil will drain out from the gear leg.
5. Attach oil fi lling equipment to the lower oil drain hole. (M8)
6. Pump oil until oil is fl owing out of the upper oil drain hole. (Approx. 200ml)
7. Tighten upper oil drain screw.
8. Remove oil fi lling equipment.
9. Tighten the lower oil drain screw.
!
Please refer to the graphic for special considerations relating to your model
!
! Please refer to the graphic for special considerations relating to your model !
MG_0148
KEY:
1. Hydraulic Motor
2. Mounting Plate
3. Motorbracket
4. Flexible coupling
5. Gear Leg (Pre filled)
6. Propeller
7. Anode
8. Drive pin
9. Washer
10. Lock Nut
11. Fastening Screw for anode
12. Oil drain screw
13. Shaft Key
14. Anode pins
SH
* 100
* 160
* 240
SH
* 320
SH
* 420
* 550
SH
* 700
* 1000
* 1400
11
13
11
11
10
10
10
9
9
9
8
8
7
7
7
7
7
7
6
6
6
6
6
6
5
5
5
5
5
5
4
4
4
3
3
3
2
2
2
1
1
1
11
14
12
12
13
10
9
7
7
6
6
5
5
4
3
2
1