Side-Power SE 60/185 S2, Инструкция по установке и эксплуатации

Страница: 17 / 24

17
5693 2 2019
-
SE60/185 S2
Maintenance
EN
Electromotor
Directional solenoids
Motorbracket for holding motor and
gearhouse together on the tunnel.
Breakpin secures the electromotor if
propeller is jammed. Changeable from
inside the boat.
5-blade skew propeller for ultimate
performance.
Prefilled lifetime lubricated gearhouse.
Changeable anode protects gear-house
from corrosion in seawater.
7
4
5
6
1
3
2
» Retighten the bolts holding the gearhouse to the motor bracket during the first on-land service with the specified bolt tightening force.
» Keep the propeller and gearhouse clean from growth by painting with antifouling before every season.
PS! The anode, sealing and propeller shafts must absolutely not be painted. Be careful that you don’t fill paint in the “tracks” in the gearhouse that the
propeller hub moves in.
» Change the anode before every season, or when about half the anode is gone. Always use a sealant on the screw holding the anode to ensure that
it does not fall off. Please observe that in some waterconditions it can be necessary to install an extra anode to ensure that it lasts for the whole
period between regular service lifts of the boat. Consult your dealer for information on how to do this.
» As a part of the seasonal service of your boat, and before every season, always check that:
• The propeller is securely fastened
• The bolts holding the electric motor to the motor bracket are fastened correctly.
• The area where the thruster is installed is clean and dry. If there are signs of water you must try to find the source and eliminate it.
• All electrical connections are clean and fastened firmly.
• Make sure that your batteries are in a good condition so that the thruster gets a good voltage. Old or bad batteries will give a reduced performance
from the thruster.
5
3 4
1
2
Locktite
SE60/185S
Fastening screw for anode
Anode
Propeller lock nut
Washer
Drivepin for propeller
4
5
1
3
2
1
3
4
2
5
7
6