Caution – Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
DANGER
Risk of injury due to hot device surface.
The surface of the device can become hot during operation.
•
Before performing work on the device (e.g. mounting, cleaning, disassembly),
switch off the device and allow it to cool down.
•
Ensure good dissipation of excess heat from the device to the surroundings.
WARNING
Risk of injury due to falling products!
■
Secure devices and accessories when assembling or disassembling, for example
with a second person.
WARNING
Electrical voltage!
Electrical voltage can cause severe injury or death.
■
Work on electrical systems must only be performed by qualified electricians.
■
The power supply must be disconnected when attaching and detaching electrical
connections.
■
The product must only be connected to a voltage supply as set out in the require‐
ments in the operating instructions.
■
National and regional regulations must be complied with.
■
Safety requirements relating to work on electrical systems must be complied with.
WARNING
Risk of injury and damage caused by potential equalization currents!
Improper grounding can lead to dangerous equipotential bonding currents, which may
in turn lead to dangerous voltages on metallic surfaces, such as the housing. Electrical
voltage can cause severe injury or death.
■
Work on electrical systems must only be performed by qualified electricians.
■
Follow the notes in the operating instructions.
■
Install the grounding for the product and the system in accordance with national
and regional regulations.
2.8
Warning symbols on the product
Products with LED risk group 2 carry the following warning label on their housing:
Risk group 2
CAUTION - Possibly hazardous visible radiation emitted from this
product. Do not stare at operating lamp. May be harmful to the eyes.
IEC 62471:2006-07; EN 62471:2008-09
Figure 1: Risk Group 2: Caution - Possibly hazardous visible radiation emitted from this product.
Do not look into the lamp during operation. This could damage your eyes.
The warning label must not be covered when installing the product in a machine or
paneling.
SAFETY INFORMATION
2
8023775/1A4I/2020-12-01 | SICK
T E C H N I C A L I N F O R M A T I O N | Camera ICD880/890 Generation 4
11
Subject to change without notice
