Shur-Co AutoGate, Руководство пользователя

Страница: 7 / 16

P/N 1128479 Rev. A
Stop Plate and Brackets Installation - continued
STEP 7: Place actuator
4
between hinge bracket and gate
bracket
5
. Use screw
B
and pin
T
to temporarily
hold actuator.
STEP 8: Align hinge brackets so actuator is level. Hold hinge
bracket in place and remove actuator. Mark holes (2
holes on front and 2 holes on side) for drilling. For 4"
posts, use inner holes, and for larger posts, use outer
holes.
STEP 9: Drill holes and install fasteners. For wooden posts, use
either carriage bolts or lag screws. For metal posts,
use carriage bolts.
STEP 10 : Place actuator back on hinge bracket. Place only one
cap screw in hinge bracket to allow actuator to pivot on
hinge bracket. Do not place nut at this time. Push gate
fully open. Swing actuator towards gate until actuator
points towards gate bracket
5
. If actuator body makes
contact with gate, adjust inner slide hinge bracket
3
out farther by one hole location. Alternatively, if there
is adequate clearance between actuator and gate,
inner slide hinge bracket may be brought closer to
hinge post by one hole location.
STEP 11 : Remove actuator and tighten all fasterners holding
inner slide hinge bracket to outer slide hinge bracket.
● If using 3/8" carriage bolts
F
, drill 3/8" holes through post.
● If using 3/8" lag screws
E
, drill 1/4" holes into post at least
2-1/2" deep.
4
4
5
hinge bracket
hinge bracket
inner holes
outer holes
5
5
4
4
B
E
F
N
T
P
K
gate and actuator
should not touch
gate fully opened
gate
post