Shundaiwa C260, Руководство владельца/оператора

Страница: 7 / 28

7
Assembly: Driveshaft/Powerhead All Models
1. Place the powerhead on a clean, flat
surface, spark plug facing up.
2. Use the 4 mm
hex wrench to
loosen the tube
clamp screw.
3. Slide the outer
tube into the
tube clamp until
the tube bot-
toms. If installa-
tion is difficult,
rotate the outer
Tube Clamp
Hex Wrench
tube or gearcase output shaft slightly un-
til you feel the mainshaft splines engage
with the powerhead.
4. Position the outer tube so that the
gearcase output shaft is facing down
(opposite the spark plug).
T260/T260X/LE260 — Slide the
outer tube into the powerhead until
the throttle grip just contacts the tube
clamp.
Connect the Outer Tube
to the Powerhead.
CAUTION!
Do not force the outer tube into the
powerhead! Excessive force can
damage the outer tube and mainshaft.
Clamp must fit next to line on
outer-tube decal
T260/T260X
LE260
Powerhead
Outer
Tube
Decal
C260 Brushcutter
Mainshaft
Clamp Screw
Throttle Assembly
Tube Clamp
Clamp
Figure 6
Figure 5
Spark Plug
C260 — Slide the outer tube into the
powerhead until the installation decal
aligns with the tube clamp.
5. Tighten the clamp screw firmly.
Assembly: Handle T260
Handle
Socket-head
Cap Screw
Outer Tube
Trigger Housing
Figure 7
Handle Positioning Label
Connect the Handle
to the Outer Tube.
1. Position the handle on the outer tube
forward of Handle Positioning Label as
shown in Figure 7.
2. Install the mounting bracket with the
socket head cap screws. Tighten the
screws finger-tight ONLY at this time.
3. Locate the handle in the best position
for operator comfort (usually about 10
inches ahead of the throttle housing).
4. Secure the handle by alternately tighten-
ing the four socket-head screws in a
diagonal or “crisscross” fashion.
Mounting Bracket