Shundaiwa C260, Руководство владельца/оператора

Страница: 13 / 28

13
1. Turn the trimmer over so that the
gearcase output shaft faces UP.
2. Remove and discard the vinyl shaft
protector.
3. Position the tool holder as shown, and
slide the holder onto the output shaft.
4. Rotate the tool holder and shaft until the
notch in the holder aligns with the notch
on the gearcase flange, and use the long
end of the hex wrench to lock the output
shaft in position. See Figure 16.
5. While holding the hex wrench, thread
the trimmer head onto the output shaft
in a counter clockwise rotation. Using
hand pressure only, tighten the trimmer
head firmly on the gearshaft.
IMPORTANT!
The trimmer head has a left-hand thread.
Turn the trimmer head counter-clockwise
to install.
6. Remove the hex wrench.
Assembly: Trimmer Head T260
1
2 3
Remove
Protector
Position
Tool
Holder
Align Notches
Install trimmer head
Install the Trimmer Head.
The T260 grass trimmer
should now be completely
assembled and ready for use as a
grass trimmer. For instructions
on installing a blade on a C260 or
T260X, see page 14.
C260
T260X
WARNING!
A standard T-series unit should NEVER
be operated with blade-type attachments.
For blade use the trimmer must first be
fitted with a bicycle-type handlebar or
barrier bar that is located in front of the
operator to reduce risk for the operator to
come in contact with cutting attachment
(per ANSI B175.3). When using a blade,
the unit must be equipped with a harness
or a strap.
Hex
Wrench
Figure 16
To install a
trimmer head onto
a C260 or T260X
unit, first remove the
shaft bolt, bolt guard
and safety clip
(see page 14).