Shundaiwa C260, Руководство владельца/оператора

Страница: 10 / 28

10
1. Loosen and remove the throttle lever
clamp screw “A”, and slide the throttle
assembly about 1-inch away from the
handgrip.
2. Extend the throttle lever (inset).
3. Push the throttle cable and switch wires
through the handgrip until it appears at
the throttle assembly.
4. Insert the throttle cable end into the
socket on the throttle lever.
5. Retract the throttle lever to its original
position.
6. Using finger pressure only, gently push
the red and black ignition wires onto
the connectors underneath the throttle
assembly
7. Slide the throttle assembly back to its
original position, and then replace and
tighten the throttle lever clamp screw
“A”.
Install the Throttle Cable (C260)
Assembly: Throttle Linkage and Ignition Leads C260
Insert ignition wires
onto connectors (not
color coded)
Handlebar
not shown for
clarity
Insert Throttle
Cable End
Throttle Lever (shown
extended)
Throttle Cable
and Switch
Wires
About 1
inch
Throttle As-
sembly
Clamp
Screw “A”
Handgrip
Nut
Figure 12