Shundaiwa C260, Руководство владельца/оператора

Страница: 19 / 28

19
DO N
OT
C
UT
Ten
O'clock
OK To Cut
Eight
O'clock
Five
O'clock
Blade
Rotation
Figure 34
Using a Brushcutter Blade C260/T260X
WARNING!

Before working with a blade-
equipped unit, always inspect and
clean the area of objects that could
interfere with or damage the blade.

Never use a blade near sidewalks,
fence posts, buildings or other
objects that could cause injury or
damage.

Never use a blade for purposes
other than those for which it was
designed.

Whenever you strike a hard ob-
ject with a blade, always stop the
brushcutter and carefully inspect
the blade for damage. NEVER
OPERATE THE BRUSHCUTTER
WITH A DAMAGED BLADE!

A blade-equipped unit must be
equipped with a bicycle-type handle-
bar or barrier bar as well as a har-
ness or strap.

Always make sure the cutting at-
tachment shield is properly installed
before operating your unit.
Blade Thrust
‘Blade thrust’ is a sudden sideways or
backward motion of the brushcutter. Such
motion may occur when the blade jams or
catches on an object such as a sapling tree
or tree stump. BE CONSTANTLY ALERT
FOR BLADE THRUST AND GUARD
AGAINST ITS EFFECTS!
Brushcutter Handlebar
A brushcutter handlebar helps prevent the
operator from moving forward, or the unit
moving rearward, thus preventing inadver-
tent bodily contact with the blade. ALWAYS
KEEP THE HANDLEBAR SECURELY IN
PLACE ON THE UNIT!
Brushcutter Shoulder Strap
A shoulder strap provides additional protec-
tion against blade thrust. In addition, a
shoulder strap gives significant support
and comfort to help ensure safe and ef-
ficient operation.
When operating a T260X or C260 with a
blade, make sure both the handle and har-
ness are adjusted to the size of the operator
using the unit.
Engine Operating Speeds
Operate the unit at full throttle while cut-
ting. Best fuel efficiency is obtained by
releasing the throttle when swinging back
after a cut.

To prevent possible engine damage, do
not allow the brushcutter to run at high
speeds without a load.

Avoid operating the engine at low
speeds. Doing so can lead to rapid
clutch wear. In addition, slow-speed op-
eration tends to cause grass and debris
to wrap around the cutting head.
The blade rotates counter-clockwise. For
best performance and to minimize being
stuck by debris, move the blade from right
to left while advancing on your work.
Position the blade so cuts are made be-
tween the blade’s 8 o’clock and 10 o’clock
positions (as viewed from above). DO NOT
cut between the 10 o’clock and 5 o’clock
positions.
WARNING!
When cutting wood with a saw, feed
the blade slowly— never strike or
“slam” a spinning blade against the
wood.
WARNING!
DO NOT use 2-tooth or non-Shindaiwa
approved 4-tooth cutting blades with
Shindaiwa trimmers and brushcutters.
Vertical Cuts
Hold the brushcutter with the blade at
a 90° angle to the ground so the blade’s
bottom edge rotates toward the operator.
Move the blade from top to bottom through
the cut, and cut
only
with the bottom edge
of the blade.
WARNING!!
When making vertical cuts, never allow
the blade to exceed waist height.
Cut on the left
side of the blade.
KEEP YOUR BODY
OUTSIDE THE
PATH OF BLADE
ROTATION
Figure 35