SHOWTEC Showdesigner 1024, Руководство по эксплуатации продукта

Страница: 11 / 20

9
Installation
Remove all packing materials from the Showdesigner 1024 . Check that all foam and plastic padding is
removed. Screw the equipment into a 19" rack. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
2.1 General Operations
2.1.1 Power on:
After powering on, the device will reset itself. The LED indicators will blink.
2.1.2
Fixture selection:
After power on, the fixture buttons are deactivated and the sliders will not work. Press the fixture selection
buttons to select the fixtures.
1. 1-32 fixtures can be selected. If the LED indicator of the button is on, it means the fixture is
selected. The flashing LED indicators of the sliders indicate the output status of the fixture.
2. Two or more fixtures can be activated or deactivated simultaneously. E.g. If you want to activate
or deactivate 10 fixtures, press and hold the first button and then press the 10
th
button, now
fixture1-10 will be either activated or deactivated simultaneously.
2.1.3 Manual control:
After activating the fixtures, you can both control the fixtures by pushing the faders. If the fixtures do not
response to the faders, push the slider to the bottom and try again. The brightness of the faders’ LED
indicators give an indication of the output value. If the indicator is flashing it means the output value on
the fader is 0. The output by manual control is prior to the output by a running scene/ chase/ chase
group. Press and hold
release then push a slider, the output of the channel by manual control will be
released.
Note:
Press and hold release , then push a fader to release the channel and the LED indicator will dim. On the
other hand if there is a scene/ chase or chase group running on that channel, the brightness of the LED
indicator will change according to the output value.
Press
clear to clear all manual output. All the LED indicators of the sliders will dim.
Manual output is prior to the output of a running scene/ chase/ chase group.
2.1.4 Clear
1. If one of the LED indicators of sc1 , sc2 , sc3 , chase1 , chase2 , chase3 , group1 or group2 is lit, press clear
once, this will clear all manual output.
2. If one of the LED indicators of
sc1 , sc2 or sc3 is lit, press clear and hold for about one second. It will
clear all manual output and close all running scenes.
3. If one of the LED indicators of
chase1 , chase2 or chase3 is lit, press clear and hold for about one
second. It will clear all manual output and close all running chases.
4. If one of the LED indicators of
group1 or group2 is lit, press clear and hold for about one second. It will
clear all manual output and close all running chases.