SHOWTEC Showdesigner 1024, Руководство по эксплуатации продукта

Страница: 7 / 20

5
Controller Front
1) Fixture selection buttons
There are 32 buttons with 32 fixed DMX channels, all for
direct fixture selection. If a fixture is selected, the LED
indicator in the button will light.
If the LED indicator of the fixture selection button blinks,
the LED indicator of the according fader will show the
status of the fixture.
Either one or several fixtures at the same time can be
activated or deactivated. E.g.: to activate fixture 4, 5,
6, 7, 8, 9 and 10 simultaneously, press and hold button 4
and press button 10. Now fixture 4, 5, 6, 7, 8, 9 and 10 are
all selected.
Note:
According to the DMX512/ 1990 standard, each DMX output can address a maximum of 512 channels.
Therefore the 1024 channels in this controller are split in 2 sets. Buttons
1-16 are send to the LINE 1outputs.
Buttons 2-32 are send to the LINE 2 outputs.
2) Sliders and LED indicators
The unit has 32 faders, each with a LED indicator. By using the Fixture buttons and the faders you can
control all 1024 channels in real time. The 16 faders at the bottom can be used as master faders.
3) Function buttons
Release:
During playback of a chase moving faders will not have any effect. If you want to
use the fader anyway, press release.
LightCopy:
Use this button for copying data from one fixture to another. First, adjust the
channels of one fixture by adjusting the faders, then press and hold
LightCopy + the current fixture selection until the LCD display shows “ Copy OK ”.
Press and hold LightCopy again + the button of the target fixture until the display
shows “ Paste OK ”. Now you’ve copied the data of one fixture to another.
Clear:
The function of this button varies with the state of the device.