SHOWTEC Performer Profile 600, Инструкция по эксплуатации

Страница: 17 / 32

16
Ordercode: 33060
Performer Profile 600
Control Modes
There are 3 modes:
• Stand-alone (Run)
• Master/Slave
• DMX-512 (1CH, 2CH, 3 CH)
One Performer (Run Mode)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Performer is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 24 for more information about the Run Mode.
Multiple Performers (Master/Slave control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin XLR cable to connect the Performer.
The pins: 01) Earth
02) Signal -
03) Signal +
03)
Link the units as shown in fig. 12. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on page 24 (Run Mode). This
means that you can set your desired operation mode on the master device and all slave devices
will react the same as the master device.
Multiple Performers (Master/Slave control)
Fig. 12