SHOWTEC LED Spere & Cube Controller 30, Руководство пользователя

Страница: 13 / 15

11
DMX Protocol - 48 Channel Mode
Channel 1 – Red Sphere/Cube 1
Channel 2 – Green Sphere/Cube 1
Channel 3 – Blue Sphere/Cube 1
Channel 4 – Dimmer Sphere/Cube 1
Channel 5 – Red Sphere/Cube 2
Channel 6 – Green Sphere/Cube 2
.
.
.
Channel 47 – Blue Sphere/Cube 12
Channel 48 – Dimmer Sphere/Cube 12
Maintenance
The Showtec 19” LED Sphere & Cube Controller 30 requires almost no maintenance. However, you should
keep the unit clean. Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do
not immerse in liquid. Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the DMX and audio connections with a
damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric
power.
Troubleshooting
Showtec LED Sphere & Cube Controller 30
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following steps.
1. If the device does not operate properly, unplug the device.
2. Check power from the wall, all cables, the fuse, etc.
3. If all of the above appears to be O.K., plug the unit in again.
4. If nothing happens after 30 seconds, unplug the device.
5. Return the device to your Showtec dealer.