SHOWTEC LED Spere & Cube Controller 30, Руководство пользователя

Страница: 7 / 15

5
Installation
Remove all packing materials from the LED Sphere & Cube Controller 30. Check that all foam and plastic
padding is removed. Connect all cables.
Note:
It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure proper
transmission on the DMX data link.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Menu Settings
Menu Value Description
COL 0-7 0-Blackout, 1-R, 2-G, 3-B, 4-Y,5-C, 6-M, 7-W
CHS 0-15 Built-in chases
SPD 1-16 Speed Control
CHA 0-511 DMX Address
CE 4 or 48 Channel Control
SOU ON / OFF Sound-controlled