SHOWTEC EVENTLITE 6/3, Руководство пользователя

Страница: 17 / 28

16
Ordercode: 44000
EventLITE 6/3 WDMX
Control Panel
Fig. 09
A) Battery indicator LEDs B) LCD Display
C) WDMX indicator LED D) MODE button
E) SETUP Button F) Up Button
G) Down Button H) Wireless DMX Unlink button
I) ON/OFF switch
DMX Control Mode
The fixtures are individually addressed on a data-link and connected to the controller. When a DMX
signal is present, the green LED (C) will blink. The fixtures respond to the DMX signal from the controller.
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the EventLITE 6/3 WDMX will respond to the controller. Please note when you use
the controller, the unit has up to
5 channels. When using multiple EventLITE 6/3 WDMX, make sure you set
the DMX addresses right. Therefore, the DMX address of the first EventLITE 6/3 WDMX should be 1(001) ; the
DMX address of the second EventLITE 6/3 WDMX should be 1+5=6(006) ; the DMX address of the third
EventLITE 6/3 WDMX should be 6+5=11(011) , etc. Please, be sure that you do not have any overlapping
channels in order to control each EventLITE 6/3 WDMX correctly. If two or more EventLITE 6/3 WDMX are
addressed similarly, they will work similarly.
Controlling:
After having addressed all EventLITE 6/3 WDMX, you may now start operating these via your lighting
controller.
Note: After switching on, the EventLITE 6/3 WDMX will automatically detect whether DMX 512 data is
received or not. The problem may be:
• The XLR cable from the controller is not connected with the input of the EventLITE 6/3 WDMX.
• The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
The EventLITE 6/3 WDMX will only show its version number at start-up!