SHOWTEC EVENTLITE 6/3, Руководство пользователя

Страница: 25 / 28

24
Ordercode: 44000
EventLITE 6/3 WDMX
See the table below for more problem solving.
Problem: Probable cause(s): Remedy:
One or more
fixtures do not
function.
No power to the fixture
 Check whether the power is
switched on, the power cable is in
order, the cable is connected
and/or the battery is charged
Fixtures reset
correctly, but all
respond
erratically or not
at all to the
controller. The controller is not connected.  Connect controller.
3-pin XLR Out of the controller
does not match XLR Out of the first
fixture on the link (i.e. signal is
reversed).
 Install a phase reversing cable
between the controller and the
first fixture on the link.
Fixtures reset
correctly, but
some respond
erratically or not
at all to the
controller.
Poor data quality
 Check data quality. If much lower
than 100 percent, the problem
may be a bad data link
connection, poor quality or
broken cables, missing termination
plug, or a defective fixture
disturbing the link.
Bad data link connection
 Inspect connections and cables.
Correct poor connections. Repair
or replace damaged cables.
Data link not terminated with 120
Ohm termination plug.  Insert termination plug in output
jack of the last fixture on the link.
Incorrect addressing of the fixtures.  Check address setting.
One of the fixtures is defective and
disturbs data transmission on the
link.
 Bypass one fixture at a time until
normal operation is regained:
unplug both connectors and
connect them directly together.
 Have the defective fixture
serviced by a qualified
technician.
3-pin XLR Out on the fixtures does
not match (pins 2 and 3 reversed).
 Install a phase-reversing cable
between the fixtures or swap pin 2
and 3 in the fixture that behaves
erratically.
No light
Fixture is too hot.
 Allow fixture to cool.
 Make sure air vents at the control
panel and the front lens are not
obstructed.
 Turn up the air conditioning.
LEDs are damaged
 Disconnect the fixture and return
it to your dealer.