SHOWTEC 50705, Руководство пользователя

Страница: 10 / 24

9
Order code: 50705
ColorCue 3
● RGBA/UV
● RGBWA/UV (default mode)
● RGBAW/UV
● Dimmer (white only)
03) Press the FIXTURES button (01)–(24) once again to cancel the selection of the fixtures in step 1. The
LEDs on the buttons will turn off. Skip steps 3 and 4, if you have selected the same LEDs type for all
connected fixtures in step 1.
04) Repeat steps 1–3 to set up the LEDs types for the remaining fixtures.
DMX Starting Address of the Connected Fixtures
The ColorCue 3 calculates automatically the starting DMX address of each connected fixture depending
on the LEDs type setup. Each color is controlled on a separate DMX channel. However, there are no
reserved DMX channels for each color and only the active channels are used.
For example, if you want to connect 3 fixtures with RGB LEDs and 3 fixtures with RGBWA/UV LEDs, the
starting DMX address of the connected 6 fixtures will be as follows:
Fixture FIXTURES button LEDs Type Channels Starting DMX address
Fixture 1 01 RGB 3 001
Fixture 2 02 RGB 3 004
Fixture 3 02 RGB 3 007
Fixture 4 04 RGBWA/UV 6 010
Fixture 5 05 RGBWA/UV 6 016
Fixture 6 06 RGBWA/UV 6 022
... ... ... ... ...
The starting DMX address of the last selected fixture is displayed on the setup mode screen.
●
Approach 1: If you want to note down the starting DMX addresses, select one fixture first,
change the LEDs type and then select the rest of the fixtures. Thus, each time the
screen will display the correct starting DMX address of each fixture.
● Approach 2: If you select all fixtures first and then set the LEDs type, only the starting DMX
address of the last fixture will be displayed on the screen.
There are no functional differences between Approach 1 and 2.
MIDI Address Setup
In setup mode press the UP/DOWN buttons (25)/(28) to assign the MIDI address of the ColorCue 3. The
selection range is 1–16. Refer to MIDI Implementation Chart on page 21 for more information.
Control Modes
The device has 2 control modes:
●
Double (12-fixture) mode, and
● Single (24-fixture) mode.
Press the FIXTURES button (30) to toggle between double and single control mode. In single mode the LED
on the button will light up in red and in double mode in green.
Double (12-Fixtures) Mode
In double (12-fixtures) mode you can control up to 12 fixtures. You can create scenes in Bank A and
Bank B. In manual operating mode you can crossfade between the scenes in Bank A and Bank B.
In double mode the FIXTURES buttons and faders (01)–(12) control Bank A scene values of the connected
up to 12 fixtures, and the FIXTURES buttons and faders (13)–(24) control Bank B scene values of these
fixtures. In this mode BANK A master fader and flash button (K) control the Bank A output, and BANK B
master fader and flash button (L) control the Bank B output.
Single (24-Fixtures) Mode
In single (24-fixtures) mode you can control up to 24 fixtures. You can create single scenes. It is not
possible to work with Bank A and Bank B scenes in this mode. However, you can still transition between
the scenes but without crossfading.