21
ACT Fresnel 150 WW
Product code: 34012
Control Modes
The ACT Fresnel 150 WW can be operated with a DMX controller and as a stand-alone device.
The ACT Fresnel 150 WW supports the following control modes:
●
Stand-alone:
Manual operation
●
DMX-512:
1 channel and 2 channels
For more information about how to connect the devices, refer to 5. Setup on pages 17–19.
You can operate the device manually as a stand-alone device in 2 ways:
●
from the control panel and the menu, and
●
with the manual dimmer control (17). See 6.7.2. Manual Settings on page 26 for more information.
To operate the device manually from the control panel and the menu:
Select Manually Defined in the Mode pop-up submenu. See 6.7.2. Manual Settings on page 26 for
more information.
Adjust the dimmer and shutter values in the Manually Defined submenu. See 6.7.5.1. Manually
Defined on page 28 for more information.
To operate the device with a DMX controller:
Set the DMX starting address of the device in the DMX Address menu. See 6.7.1.1. DMX Address on
page 25 for more information.
Select the behavior of the device in case there is no DMX signal in the DMX Fail pop-up submenu.
See 6.7.1.3. DMX Fail on page 25.
Select the DMX channel mode in the DMX channel mode menu. See 6.7.1.2. DMX Channel Mode on
page 25 for more information. See 6.8. DMX Channels on pages 30 for complete overview of all DMX
channels.
Control Panel
A)
OLED display
B)
ENTER button
C)
DOWN button
D)
UP button
E)
MENU button
Fig. 17
●
Use the MENU button to exit the current submenu, to return to the Main Menu and to return to the
start screen.
●
Use the UP/DOWN buttons to navigate through the menus or to increase/decrease numeric values.
●
Use the ENTER button to open the desired menu, to confirm your choice or to set the currently
selected value.
