19
ACT Fresnel 150 WW
Product code: 34012
DMX Addressing
In a setup with multiple devices, make sure that you set the DMX starting address of each device
correctly. The ACT Fresnel 150 WW has 2 personalities: 1 channel and 2 channels.
If you want to connect multiple devices on one data link and use them in 2-channel mode, for example,
follow the steps below:
Set the starting address of the 1
st
device on the data link to 1 (001).
Set the starting address of the 2
nd
device on the data link to 3 (003), as 1 + 2 = 3.
Set the starting address of the 3
rd
device on the data link to 5 (005) as 3 + 2 = 5.
Continue assigning the starting addresses of the remaining devices by adding 2 to the previous
number each time.
Make sure that you do not have any overlapping channels in order to control each ACT Fresnel 150 WW
correctly. If two or more devices are addressed similarly, they will work similarly.
Beam Angle Adjustment
The beam angle of the ACT Fresnel 150 WW can be adjusted manually in the range 14°–44°. To adjust the
beam angle, follow the steps below:
Turn the zoom control (05) counterclockwise to loosen it.
Slide the zoom control (05) forwards or backwards to achieve the desired beam angle (see Fig. 16).
After adjusting the beam angle, turn the zoom control (05) clockwise to tighten it. Do not
overtighten it.
Fig. 16
