SL LEDSPOT 300 Luminaire
Quickstart Guide
SL LEDSPOT 300 QuickStart Guide
3
Introduction
Included Items
Each SL LEDSPOT 300 includes the following items:
Figure 1: Included Items
Warnings and Notices
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
·
Do not use outdoors.
·
Do not mount near gas or electric heaters.
·
Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.
·
The use of accessory equipment not recommended by the manufacturer and may cause an unsafe condition..
·
Do not use this equipment for other than intended use.
·
Refer service to qualified personnel
.
SAVE THIS DOCUMENT FOR FUTURE REFERENCE! READ COMPLETELY BEFORE INSTALLING AND USING PRODUCT!
WARNING
: You must have access to a main circuit break error other power disconnect device before installing any wiring. Be sure that power is
disconnected by removing fuses or turning the main circuit breaker off before installation. Installing the device with power on may expose you to
dangerous voltages and damage the device. A qualified electrician must perform this installation.
WARNING
: Refer to National Electrical Code® and local codes for cable specifications. Failure to use proper cable can result in damage to
equipment or danger to personnel.
WARNING
: This equipment is intended for installation in accordance with the National Electric Code® and local regulations. It is also intended for
installation in indoor applications only. Before any electrical work is performed, disconnect power at the circuit breaker or remove the fuse to avoid
shock or damage to the control. It is recommended that a qualified electrician perform this installation.
Service and Maintenance
For all service and maintenance issues, please contact your local Showline office or an Authorized Service Center.
Power Requirements
The SL LEDSPOT 300 operates on AC input voltages from 100 to 240 V AC.
WARNING
: This unit does not contain an ON/OFF switch. Always disconnect power input cable to completely remove power from unit when
not in use.
AC Power Operation
When connected to an AC source, the unit operates on 100 to 240 volts AC (+/- 10%, auto-ranging). The luminaire contains an auto-ranging power
supply.
Each luminaire can draw up to 4
5
0 Watts.
About Quickstart Guide
This Quickstart Guide is intended for a knowledgeable user to unpack, install, and use SL LEDSPOT 300 in a short time period. For the complete
manual in PDF format, please visit our web site at :www.philips.com/showline and click the user manual download link on the product page. The
complete manual provides you all information related to accessories, menu structures, DMX channel mapping/modes, and care for your new
luminaire.
