INSTRUCTIONS
SHARK
®
INSTALLATION
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
Surface Mounting Bracket
(2)
Housing
Lens and Tray Assembly
Tether Cable
Latch
Surface Mounting Bracket
Conduit Plug
(3)
Mounting Surface
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding
is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
CAUTION: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened
firmly. Apply weatherproof silicone sealant around the edge of the ceiling mounting box and/or junction box. This is
especially important with an uneven ceiling surface. Silicone all plugs and unused conduit entries.
SURFACE MOUNTING
The fixture is suitable for outdoor applications in wet locations
either ceiling or wall mounted.
1. Use appropriate mounting screws (not supplied) to secure the
Surface Mounting Brackets
(2 included)
to
Mounting Surface
.
Recommended
Surface Mounting Brackets
distance center to
center is 14-5/8”
(for SHARK2)
and 37”
(for SHARK4)
.
NOTE:
Mount
Surface Mounting Brackets
(2)
symmetrical
about the center of the fixture and aligned with each other.
2. Unlatch the
Lens and Tray Assembly
from
Housing
.
Pre-installed
Tether Cables
(2)
will prevent
Lens and Tray
Assembly
from falling down as shown in Fig. 1.
3. Feed supply wires through one of the
Conduit Plugs
(3)
to
make electrical splices. Cord-grips
(2)
are provided and can be
used based on the application.
4. Use appropriate UL approved wire connectors as required by
code to complete wiring with supply wires. Be careful not to
pinch the wires.
WARNING: To prevent wiring damage or abrasion, do not
expose wiring to edges of sharp objects.
5. Secure
Lens and Tray Assembly
to
Housing
by clamping
Latch
down. Be careful not to pinch the wires. Check that the Gasket
is fully seated.
6. Push
Housing
into
Surface Mounting Brackets
(2)
as shown in
Fig. 2. Ensure that the
Housing
is secure to
Surface Mounting
Brackets
(2).
7. Use silicone or Teflon tape on all
Conduit Plugs
and on the
threads of all conduit entry points. If outdoor surface is irregular,
use caulk to seal any gaps around
Housing
.
Fig: 1
Fig: 2
SHARK - 2FT
SHARK - 4FT