Shop-Vac WAIR Series, Руководство пользователя

Страница: 4 / 24

This appliance is for use on a nominal 120-volt circuit, and has a grounded plug that looks like the plug
illustrated in sketch A . A temporary adaptor that looks like the adaptor illustrated in sketches B and C may
be used to connect this plug to a 2-pole receptacle as shown in
sketch B
if a properly grounded outlet is
not available. The temporary adaptor should be used only until a properly grounded outlet
(sketch A)
can
be installed by a qualified electrician. The green colored rigid ear, lug or the like extending from the adaptor
must be connected to a permanent ground such as a properly grounded outlet box cover. Whenever the
adaptor is used, it must be held in place by a metal screw.
IN CANADA, THE USE OF A TEMPORARy ADAPTOR IS NOT PERMITTED by THE CANADIAN ELECTRICAL
CODE. Make sure that the appliance is connected to an outlet having the same configuration as the plug. No
adaptor should be used with this appliance.
UNPACKING
Unpack air circulator from carton. Lift unit using the top carry handle.
ASSEMBLY
NOTE:
This unit is for use with the included wall mounting bracket or mobile floor mounting bracket (not
included, sold separately).
MOUNTING INSTRUCTIONS
you will find one mounting bracket, three hex head screws, one pivot tube, two bolts, two washers and two
lock nuts. Assemble as follows:
1. Select a mounting location at a wall stud or a surface that is strong enough to hold the weight of the
unit. Make sure the unit has enough clearance on each side to allow for proper airflow.
WARNING
–
INADEqUATE MOUNTING COULD ALLOW THE UNIT TO FALL,
CAUSING INJURY AND/OR DAMAGE TO THE UNIT.
2. To make it easier to secure the mounting bracket, it is recommended to drill pilot
holes in the mounting surface. To do this, place the bracket against the wall or ceiling
in the selected mounting location. Make sure bracket is level. Use a pencil to mark
the location of the holes (located in the bracket) onto the wall or ceiling. Remove the
bracket and use a 3/16” drill bit to drill holes where the pencil marks are on the wall
or ceiling.
3. Secure the bracket to the mounting surface with the three screws provided or other
suitable fastener.
NOTE:
The screws provided are adequate ONLy for mounting into
wood. be sure to use the proper, suitable fasteners for mounting air circulator to a
surface other than wood. Make sure bracket is level.
4. Slide the pivot tube onto the end of the bracket. Line up the slot on the pivot tube with
the hole in the bracket.
5. Place the washers onto the bolts. Insert one of the bolts, with the washer, through the
slot on the pivot tube and then into the hole in the wall bracket. Place lock nut on end
of bolt and hand tighten only.
SKETCH A SKETCH B SKETCH C
GROUNDING METHODS
PAGE 4