FILTER
INSTALLATION
AND CLEANING
DRY PICK UP
14. Insert machine hose end with locking-nut into inlet
of tank. Turn locking nut to tighten. Do not over-tighten.
15. Attach the extension wands
to the accessory end of the
hose. Twist slightly to tighten
the connection.
FIGURE 11.
16. Attach one of the cleaning accessories (depending
on your cleaning requirements) on the extension wands.
Twist slightly to tighten the connection.
FIGURE 11.
17. Plug the cord into the wall outlet. Your cleaner is
ready for use
I = ON
,
O = OFF
.
GENERAL SET UP
FIGURE 11
NOTE:
If foam sleeve
(not standard with all models)
is installed on lid cage, remove before installing the
cartridge filter.
18. The cartridge filter can be used for dry pick up and
small quantities of wet pick up. Installation is the same
for both. When picking up large quantities of water we
recommend using a foam sleeve
(not standard with
all models)
instead of the cartridge filter. When picking
up fine dust or powders a high efficiency filter bag
(not
standard with all models)
must be used with the
cartridge filter.
NOTE:
If cartridge filter has been used for wet pick
up, it must be cleaned and dried before using it for dry
pick up.
19. With the tank cover in an
upside down position, slide
the cartridge filter down over
the lid cage, pushing until the
filter seals against the cover.
FIGURE 12.
20. Place filter retainer into the
top of the cartidge filter.
FIGURE 13.
21. Hold the tank cover with
one hand, turn the handle on
the filter retainer clockwise to
tighten, locking the filter into
place.
FIGURE 14.
22. To remove the filter for
cleaning, again hold the
tank cover and turn the filter
retainer counter-clockwise to
loosen and remove.
FIGURE 15.
PAGE 6
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
WARNING!
Questions?
U.S. Customers
call
888-822-4644
or visit
www.shopvac.com
24 hours a day.
Canadian Customers
call
905-335-9730
or visit
www.shopvac.ca
24 hours a day.
12. Before replacing tank cover, refer to
Dry Pick
Up
or
Wet Pick Up Operation
in user manual
to ensure you have the proper filters installed for your
cleaning operation.
13. Replace tank cover, and apply pressure with thumb
to each latch until it snaps tightly into place. Make
certain all lid latches are clamped securely.
NOTE:
Never use the vacuum for dry pick up without a
dry use filter installed on the lid cage. Using the vacuum
without a filter will cause dust to discharge from blower
port and cause damage to motor.
FIGURE 12
FIGURE 13
FIGURE 14
FIGURE 15
INSTALLING AND CLEANING THE CARTRIDGE
FILTER:
NOTE:
Many more useful tools are available at your
local dealer or the Shop-Vac® website.
Содержание SL14 SERIES
Страница 36: ......
