Shop-Vac SL14 SERIES, Руководство пользователя

Страница: 6 / 36

Pull lid latches in an outward motion and remove tank
cover. Remove any accessories and literature that may
have been packed in the vacuum tank.
UNPACKING
PAGE 5
1. You will find four caster
feet
FIGURE 1
, four casters
FIGURE 2
, and four screws
with your wet/dry vacuum.
Assemble as follows:
3. With tank drain facing you,
take caster feet marked with
letter
A
and place in slots on
left front and right rear of tank
also marked with the letter
A
.
FIGURE 3
.
A
A
A
A
4. Secure with screws provided.
FIGURE 4
.
B
B
B
B
A
A
5
. Take caster feet marked
with the letter
B
and place on
right front and left rear of tank
also marked with the letter
B
.
FIGURE 5
.
6 . Secure with screws provided
FIGURE 6 .
7. Insert casters into feet by
placing stem of caster into holes
provided. Apply pressure and
twisting motion until casters
snap into place. FIGURE 7 .
B
8. Return tank to upright position.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 7
9. With rear of unit facing you,
take tool holder and position it
with tabs facing rear of unit.
FIGURE 8
.
10. Place “J” shaped tabs
into the slots on cord wraps
FIGURE 9
. Press down until
tabs snap into place.
11. Press down on center of
tool holder until tab latches on
bottom of lid. FIGURE 10 .
FIGURE 6
FIGURE 8
FIGURE 9
FIGURE 10
CASTER SYSTEM
ASSEMBLY
TOOL HOLDER
ASSEMBLY
ASSEMBLY
2. With cord disconnected from receptacle and tank
cover removed, turn tank upside down so that the
bottom is facing up.