Shop fox W1825, Руководство пользователя

Страница: 55 / 76

-53-
Model W1825 (For Machines Mfd. Since 07/15)
SE
RV
IC
E
Replacing.Brake.Shoe
The brake shoe should be replaced when it takes
noticeably longer to stop the blade when the foot brake is
pushed or if the foot brake makes metal-to-metal grinding
sounds.
Contact Woodstock International Technical Support at
(360) 734-3482 to order the replacement brake shoe.
Components.and.Hardware.Needed:
Replacement Brake Shoe (Part X1825099) ..................1
Tools.Needed:
Hex Wrench 5mm ...............................................1
Hex Wrench 6mm ...............................................1
Wrench 10mm ...................................................1
Wrench 17mm ...................................................1
To.replace.the.brake.shoe,.do.these.steps:
1.
DISCONNECT BANDSAW FROM POWER!
2.
Follow
Steps.1-4.
in
Replacing.V-Belts
on
.Page.49
.
3.
Remove the cap screws, lock washers, and bushings
that secure the brake shoe to the brake lever, then
remove the brake shoe (see
Figure.82
).
4.
Install a new brake shoe onto the brake lever with
the cap screws, lock washers, and bushings removed
in
Step.3
.
5.
Re-install the V-belts onto the pulleys, then slide the
lower wheel back onto the bearing shaft.
6.
Tension the V-belts (see
Tensioning.V-Belts
on
Page.
49
).
7.
Re-install the bandsaw blade, adjust blade tension
and tracking, then adjust the upper and lower blade
guides and support bearings as needed.
8.
Close the wheel covers.
Figure.82. Brake shoe location.
Cap Screws
Brake Shoe