Shop fox W1825, Руководство пользователя

Страница: 21 / 76

-19-
Model W1825 (For Machines Mfd. Since 07/15)
SE
TU
P
Figure.21..
Correctly installed fence.
Figure.20..
Attaching resaw fence to
standard fence.
-19-
Df[\cN(/),=fiDXZ_`e\jD]^%J`eZ\*&()
J<
KL
G
=`^li\)(%
Correctly installed fence.
=`^li\)'%
Attaching resaw fence to
standard fence.
Moving
Plate
Lock Handle
Resaw Fence
20
%
Place an 8mm flat washer on the lock handle,
slide it through the hole in the fence, then thread
the moving plate onto the end of the lock handle
threads.
21
%
Slide the resaw fence over the moving plate, as
shown in
=`^li\)'
, so the moving plate fits inside
the channel of the resaw fence.
22
%
Tighten the lock handle.
23
%
Pull the fence handle up and place the fence
assembly on the front rail (see
=`^li\)(
).
24
%
Push the fence handle down to lock the fence
assembly in place.
25
%
Adjust the rail pad until there is an even gap
between the bottom of the fence and the table,
then tighten the hex nut against the fence.
)-
. Secure the guide post handwheel onto the
handwheel shaft with the included set screw (see
=`^li\))
).
Guide Post
Handwheel
Figure
))
. Guide post handwheel
installed.
20 .
Place an 8mm flat washer on the lock handle,
slide it through the hole in the fence, then thread
the moving plate onto the end of the lock handle
threads.
21 . Slide the resaw fence over the moving plate, as
shown in
Figure.20
, so the moving plate fits inside
the channel of the resaw fence.
22 .. Tighten the lock handle.
23 ..
Pull the fence handle up and place the fence
assembly on the front rail (see Figure.21 ).
24 . Push the fence handle down to lock the fence
assembly in place.
25 .
Adjust the rail pad until there is an even gap
between the bottom of the fence and the table,
then tighten the hex nut against the fence.
26
. Secure the guide post handwheel onto the
handwheel shaft with the included set screw (see
Figure.22
).
Guide Post
Handwheel
Figure 22 . Guide post handwheel
installed.