Shop fox W1825, Руководство пользователя

Страница: 25 / 76

-23-
Model W1825 (For Machines Mfd. Since 07/15)
SE
TU
P
Once assembly is complete, the next step is to test run
your machine to make sure it runs properly and is ready
for regular operation.
The test run consists of verifying the following: 1) The
motor powers up and runs correctly, 2) the OFF button
safety feature works correctly, 3) the foot brake operates
correctly, and 4) the switch key works correctly.
If, during the test, any safety feature does not work as
described, or you cannot easily locate the source of an
unusual noise or vibration, then immediately disconnect
the bandsaw from power, and refer to Troubleshooting
on
Page.59
. Make sure you resolve the problem before
proceeding with additional steps in this test run.
Test.Run
To.test.run.the.machine,.do.these.steps:
1. Make sure you understand the safety instructions
at the beginning of the manual, and verify that the
machine is set up properly.
2. Clear away all tools and objects used during setup
are from the machine.
3.
Connect the machine to the power source.
4.
Turn the switch key to "1" and reset the Stop button
by turning it clockwise until it pops out.
5. Press the ON button to turn the bandsaw ON (see
Figure.28
).
— When operating correctly, the bandsaw runs
smoothly with little or no vibration or rubbing
noises.
— Investigate and correct strange or unusual noises
or vibrations before operating the bandsaw
further.
Always. disconnect. the. bandsaw. from.
power.before.investigating.or.attempting.
to.correct.a.problem..Failure.to.do.so.
could.lead.to.serious.personal.injury.
Figure 28
. W1825 switch key and ON/OFF
switch.
Switch
Key
On Button
Stop
Button
6..
Press the OFF button to stop the machine.
7.
WITHOUT resetting the OFF button, press the ON
button. The machine should not start.
— If the machine does not start, the OFF button
safety feature is working correctly.
— If the machine does start (with the OFF button
pushed in) the OFF button safety feature is not
working correctly.
8.. Turn the bandsaw ON and allow it to
reach full speed, then press the foot
brake completely.
— If the bandsaw blade stops, the foot
brake is working correctly; continue
to the next step.
— If the bandsaw blade does not stop
moving, the foot brake feature is
not working correctly. Immediately
disconnect power.
9.
Turn the switch disabling key to "0"
(see Figure.28 ).
10. Try to turn the machine ON .
— If the bandsaw does not start, the
switch disabling feature is working
as designed. Proceed to Step.6.
— If the bandsaw starts, immediately
disconnect power. The switch
disabling feature is not working
correctly.