Shop fox W1749, Руководство пользователя

Страница: 24 / 52

-22-
W1749 9" Bandsaw
SE
T
U
P
To ensure cutting accuracy when the table is first
installed, the table should be aligned so that the miter
slot is parallel to the bandsaw blade.
To align the table so the miter slot is parallel to the
bandsaw blade, do these steps:
1.
Install the largest blade you have and make sure
that the blade is tracking properly and that it is cor-
rectly tensioned.
2.
DISCONNECT BANDSAW FROM POWER!
3.
Place an accurate straightedge along the blade. The
straightedge should lightly touch both the front and
back of the blade.
Note:
Make sure the straightedge does not go across
a tooth. Do not let the straightedge bend the blade
or measurements will be incorrect.
4.
Use a fine ruler to gauge the distance between the
straightedge and the miter slot. The distance you
measure should be the same at both the front and
the back of the table (see
Figure 35
).
•
If these measurements are not equal, loosen
the flat head screws securing the table to the
trunnion (see
Figure 16
), rotate the table until
the measurements are equal, and retighten the
screws.
• If after setting the miter gauge slot parallel with
the blade the bandsaw does not cut straight, refer
to the
Blade Lead
instructions on
Page 27
, other-
wise this procedure is complete.
Aligning Table
Figure 35.
Table alignment.
Miter
Slot