Shop fox W1749, Руководство пользователя

Страница: 17 / 52

-15-
W1749 9" Bandsaw
SE
T
U
P
The positive stop allows the table to be quickly and accu-
rately returned to the horizontal (0º) position after being
adjusted to a different angle.
To set the positive stop, do these steps:
1. DISCONNECT BANDSAW FROM POWER!
2. Using a 10mm wrench and 3mm hex wrench, loosen
the jam nut (
Figure 18
) that locks the positive stop
set screw in place.
3. Raise the upper blade guide assembly and place a
machinist's square on the table next to the side of
the blade as shown in Figure 19 . Adjust the table
square with the blade and lock in place.
4.
Adjust the positive stop screw so it just touches the
bandsaw ( Figure 20 ) and secure it by tightening the
jam nut.
5.
Check the adjustment for accuracy once you have
tightened the jam nut.
6. Loosen the screw on the pointer ( Figure 21 ) but do
not remove it.
7.
Align the tip of the pointer with the "0" mark on the
table tilt scale.
8. Tighten the screw on the pointer so that the pointer
is locked in place.
Positive Stop
Figure 18.
Positive stop.
Figure 19.
Squaring table to blade.
Positive Stop
Figure 20.
Adjusting positive stop.
Figure 21.
Adjusting pointer.
Jam Nut