13
14
E n g l i s h
Fasten the snaps in
❶
to
❸
order by
pressing the head of the snaps firmly
from the pad side until they click in
place (Drawing 14). Lastly, press the
corner (A) of the pad as shown in the
Drawing 15 and fit the cheek pad plate
securely into the boss of the cheek pad
base. Install the other cheek pad in the
same manner.
Chinstrap
Chinstrap
Jugulaire
Cheek Pad
Snap
(A)
14
13
15
E n g l i s h
Important Notice about
Handling Interior Parts
1. When fastening or unfastening the snaps, you
should hold near the snaps and treat carefully.
Fasten the snaps firmly until they click in place.
2. You can clean the interior parts by hand washing
them or by washing them in a washing machine
after placing them in a laundry net. Please treat
them carefully when washing. Use lukewarm
water. Gently squeeze the parts with a dry towel
and dry them in the shade. To prevent damage to
the plastic areas of the interior parts, do not wring
them strongly and do not fold or bend the plastic
areas. Take special care if you are using a
washing machine. Do not dry the interipr parts
with aclothes dryer, blow dryer, or any other type
of mechanical dryer, as heat can damage the
material. The impact absorbing liner (polystyrene
foam section) should be wet with a soft cloth
dipped in a solution of mild neutral soap and
water and then wiped. Allow time for the impact
absorbing liner to dry in the shade. Do not dry the
impact absorbing liner in the sunlight or use any
tupe of mechanical dryer, as the impact
absorbing liner is extremely sensitive to heat. If
the impact absorbing liner is exposed to high
heat of any kind, contract your dealer or SHOEI
directly for a safety evaluation. To prevent
damage,
do not use any of the following
cleaning materials: hot water over 40℃; salt
water, any acidic or alkali detergent; benzine,
thinner, gasoline, or other organic solvents;
glass cleaner; or any other cleaner containing
organic solvents.
E n g l i s h
Do not pass the
c h i n s t r a p
between the
plate (A) and (B)
as per Drawing.
Englis
h
E n g l i s h
After the plates are inserted, pass the chinstrap
through the hollow section of the cheek pad
(Drawing 13).