MAINTENANCE
A properly maintained machine will give you years of satisfactory service, whereas an
abused machine will not. We strongly recommend that you observe the following
procedures for your own benefit and safety.
WARNING:
Eye protection should always be worn by the operator and others in the
work area when servicing the machine Eye protection is required for
protection from flying debris and dust, which could cause eye injury.
DAILY AND WEEKLY MAINTENANCE
1.
Clean your Supreme Finisher daily.
2.
Shake dust bag and empty dust drawer daily.
After cleaning the machine, turn dust extraction motor off. While the motor is
coasting to a stop, shake bag vigorously.
Open the front door and remove the large dust tray, remove dust.
Check seal sound drawer and replace if damaged or if it is not sealed properly.
When the dust drawer is full, dust may spill when the drawer is removed. Vacuum
out the bottom of the machine before replacing the drawer for the last time.
The cleaner you keep the dust bag, the less likely you are to burn a hole in them. Failure to
shake the dust bag and empty the dust drawer daily will only increase this likelihood, but
also cause a significant loss of dust extraction from the sanding, trimming and brushing
areas.
3.
Check grindstone condition on trimmer section and replace if badly worn, chipped
or otherwise damaged.
4.
Check trimmer cutters condition daily.
Check for wear on hardened steel cutters and sharpen if necessary. (See cutter
sharpening)
Check for broken teeth on the carbide cutter, if supplied with your machine, and
replace cutter.
WARNING:
Dust from Finisher is combustible. Do not smoke while cleaning the
machine and dust collector.
12
