Shizuoka Seiki VAL6 MPX Series, Руководство пользователя, Страница: 14 / 88

12
4-1. Daily inspection
Drainage of water from the fuel tank
■
Inspecting the tip-over switch
1 While the heater is operating, grasp the
handle and shake the heater up and down,
and from side to side.
2 Check if the tip-over switch has automati-
cally extinguished the flame.
3 If the tip-over switch did not activate, shut
down the heater and contact the dealer
from whom you purchased the heater.
■
Inspection of the filter and drainage of water from the fuel tank
1 Remove the suction pipe from the fuel tank.
Checking the filter element
2 If the filter is dirty, replace it with a new one.
3 Return the suction pipe to the fuel tank and
firmly secure.
Filter
Suction Pipe
Pull off
Pull up
1 Remove the fuel cap and insert a suction
pump into the tank.
2 Remove as much fuel as possible (with the
suction pump). Be sure that the fuel being
removed is put only into a can or other con-
tainer approved in your area for holding
flammable liquids such as kerosene and
No.1 Fuel Oil.
Wrench
(24mm)
Loosen
Drain bolt
packing
Drain bolt
8 Be sure to dispose of in a safe manner as
approved in your local area the kerosene,
etc, placed in the empty container and the
materials used to clean up any spilled kero-
sene, etc. Safely clean and/or dispose of
the empty container as also approved in
your local area.
7
Wipe off kerosene or water spilled over the
tank and the surrounding area.
3 Tighten the fuel cap firmly.
4 Prepare an empty container of about 3 liters
(0.7gallons) capacity: to hold kerosene and
water remaining in the fuel tank, place the
container under the drain bolt (of the fuel
tank).
5 Next, use a 24mm wrench to remove the
drain bolt and tilt the fuel tank until the fuel is
completely drained out of the tank. (At the
same time, be careful not to lose the drain
bolt packing.)
6 Restore the drain bolt packing and tighten the
drain bolt firmly so that fuel can not leak out
(of the fuel tank).
VAL6_MPX_Multi.indb 12 14/04/01 10:52