Shire Norland Belsoe, Руководство по сборке

Страница: 16 / 30

Fig A13 example
Fi g A14
24. Open the window fully in order to fit a further 2x 25mm screws
per hinge ( Fig. A15 ).
Fig A15
25. Fitting the draught excluder. This must be done before
fitting the casement stays and latches.
Fig A16
26. Lay the assembled window unit with the opening insert
downwards onto your work surface (Fig A16).
27. Position the draught strips so the rubber is against the opening
insert and fix with 25mm oval nails, 1 at either end and approx
300mm centres per strip (Fig A16).
28. At the bottom of each window place a casement stay on top of
the draught excluder strip. Visually judge the position of the
stay so it looks central. Use a pin to judge how high to position
the stay. Fix using 2 x 25mm screws (Fig A17).
Fig A17
29. Stand the window up so it easier to fix the pins for the
casement stays
Fig A18
30. Position the first pin so it fits into the first hole on the stay
making sure it holds the window tight. Carefully remove the
stay holding the pin in position, secure pin using 2 x 25mm
screws (Fig A18) . Repeat for other pins.
Fig A19
31. Along side one of the horizontal bars ion the window insert
place the side latch on top of the draught excluder (Fig A19).
32. Use the pin to correctly place the lever and secure using
2x25mm screws for each part (Fig A19).
Fig A20
Fix the drip bar at the top of the window, there is a thin grove in
one of the flat edges this needs to be facing the bottom of the
building. Pre-drill holes and secure approx. 5mm above window
inserts using 1 x 40mm screws.(figA20) , 50mm in at each end and
approx 300mm centres.
www.simplylogcabins.co.uk