Shini SICC-120A-R2, Руководство пользователя

Страница: 26 / 44

26(44)
5) When the displayer shows Self test and please wait, continuously press
the <alarm key> and <Up key> till the screen displays plan address, and
use the <Up key> or <Down key> to modify the address to 2 or other
value (it is set according to actual demand on site. For machine No.3, set
it as 3).
6) Set the controller address of each machine in turn according to this
method.
3.8.3
Displayer Reset
1) After setting the controller address of all the Water Chillers, install the
displayer back to the host.
2) Start the mainframe of Water Chiller
3) Press the <Up key>, <Down key> and <Confirm key> at the same time,
and the screen shows display address; use <Up key> or <Down key> to
modify the address. If it needs to use Water Chillers of displayer control,
it must ensure the displayer address is set as 32.
3.8.4
Communication Connection
1) Specificaiton of Communication Connection
If the control cable needs to be crossed with the power cable, the angle of
cross point must be ensured around the 90 degrees as much as possible,
and the control cable can
’ t be parallel to the power cable.
If it needs to be connected parallelly, please refer to the national standard
(
Integrated Wiring System Project Acceptance Specification of
Architectural and Architectural Complex GB
／
T50312-2000 ) and
keep enough wire distance (
＞
130mm unshielded communication line,
＞ 70mm shielded communication line);
The distance of wire connection and heating pipeline in National standard
(GB
／
T50312-2000) is specified as below: parallel net distance
＞
500mm (unsealed heating pipe) or parallel net distance
＞
300mm (sealed
heating pipe).